Enterasys Matrix E1 1G694-13 User Manual

Matrix E1 CLI Quick Reference Guide
CLI Tasks, Commands and Syntax
A-2 Matrix E1 Series (1G694-13) Configuration Guide
Does not apply to MATRIX
CDP interval (set)
Sets the message interval frequency of the CDP discovery protocol.
For details, refer to Section 9.2.1.5.
set cdp interval frequency port_string
community (clear)
Deletes SNMP community names. For details, refer to
Section 3.2.4.3.
clear community community_name
community (set)
Sets SNMP community names and access policies. For details, refer
to Section 3.2.4.2.
set community community_ name access_ policy
community (show)
Displays SNMP community names and access policies. For details,
refer to Section 3.2.4.1.
show community
config (clear)
Clears the user-defined configuration parameters stored in NVRAM.
For details, refer to Section 9.2.1.1.
clear config
counters (show port)
Displays counter statistics detailing traffic through the switch device
and through all MIB2 network devices. For details, refer to
Section 4.2.1.2.
show port counters [port_string] [mib2 | switch]
disable (set port)
Disables one or more ports. For details, refer to Section 4.2.2.1.
set port disable port_string
disconnect
Closes an active console port or Telnet session. For details, refer to
Section 9.2.2.11.
disconnect [A.B.C.D | console]
download
Downloads a new firmware image to the device from a TFTP server.
For details refer to Section 3.2.3.2.
dload ip_address filename [noreboot]
enable (set port)
Enables one or more ports. For details, refer to Section 4.2.2.2.
set port enable port_string
CLI Task Command Function and Syntax

Enterasys Matrix E1 1G694-13 Specifications

General

Brand	Enterasys
Model	Matrix E1 1G694-13
Category	Switch
Language	English