FS TAP Series

TAP Series Switch Command Line Reference
112
NTP_MIN_DISP
Distance value time interval in milliseconds,
default is 1
Command Mode
Global Configuration
Default
The default value should be 1 millisecond.
Usage
Use this command to configure the change the minimum distance between the switch and
the NTP server.
Examples
The following example shows how to change minimum distance to 1000ms:
Switch(config)# ntp minimum-distance 1000
The following example shows how to change minimum distance to default:
Switch(config-if)# no ntp minimum-distance
Related Commands
show ntp status
10.8 ntp server
Use this command to allow the software clock to be synchronized by a Network Time
Protocol (NTP) time server.
Use the no form of this command to delete the NTP server
Command Syntax
ntp server mgmt-if IP_ADDR ( key NTP_KEYID |) (version NTP_VERSION |) ( prefer |)
no ntp server IP_ADDR