FS TAP Series

TAP Series Switch Command Line Reference
144
===============================================================
10.10.27.232 yes 162 v1 trap sysname
10.10.27.232 yes 162 v2c trap sysname
Related Commands
snmp-server trap target-address
13.7 show snmp-server inform-receiver
To display the SNMP informs receiver, use the show snmp-server inform-receiver command
in privileged EXEC mode.
Command Syntax
show snmp-server inform-receiver
Command Mode
Privileged EXEC
Default
None
Usage
This command is used to display inform receiver information configured by command snmp-
server inform target-address.
Examples
The following example shows how to display the information of snmp-server inform-receiver:
Switch# show snmp-server inform-receiver
Target-ipaddress mgmt-if udpport version pdu-type community
===============================================================
10.10.27.233 yes 162 v2c inform sysname
Related Commands
snmp-server inform target-address