FS TAP Series

TAP Series Switch Command Line Reference
22
10
Force 10Mb/s
100
Force 100Mb/s
1000
Force 1000Mb/s
2.5G
Force 2.5Gb/s
5G
Force 5Gb/s
10G
Force 10Gb/s
40G
Force 40Gb/s
100G
Force 100Gb/s
Command Mode
Interface Configuration
Default
Auto
Usage
The command is used to set the speed on port.
Examples
This example shows how to set the speed on a port to 1000 Mb/s:
Switch(config)# interface eth-0-1
Switch(config-if-eth-0-1)# speed 1000
This example shows how to reset default value of the speed on a port:
Switch(config-if-eth-0-1)# no speed
Related Commands
show interface status
show interface
1.12 duplex
Use this command to specify the duplex mode of operation for a port.