TAP Series Switch Command Line Reference
Default
Logging server default level is warning.
Usage
This command is used to set severity level while writing logs into servers.
Examples
In the following example, the user specifies that only messages of the levels error, critical,
alerts, and emergency be logged to server:
Switch(config)# logging server severity error
In the following example, set the logging server severity to default level:
Switch(config)# no logging server severity
Related Commands
show logging
12.15 logging server facility
To configure the syslog facility in which error messages are sent, use the logging server
facility command in Global Configuration mode.
Use the no form of this command to restore the default value.
Command Syntax
logging server facility (LOGFAC| auth| authpriv| cron| daemon| ftp| kern| local0| local1|
local2| local3| local4| local5| local6| local7| lpr| mail| news| syslog| user| uucp)
Authorization private system
To Next Page
Loading...
Need help?
General
