FS TAP Series

TAP Series Switch Command Line Reference
14
1.4 show interface status
Use this command to display the brief information on all physical and link aggregation
interfaces.
Command Syntax
show interface status
Command Mode
Privileged EXEC
Default
None
Usage
Use this command to display the brief information on all physical and link aggregation
interfaces.
Examples
This example shows how to display the brief information on all physical and link aggregation
interfaces:
Switch# show interface status
Name Status Duplex Speed Mode Type Description
----------+-----------+--------+--------+-------+------------+----------------
eth-0-1 down auto auto trunk UNKNOWN
eth-0-2 down auto auto trunk UNKNOWN
eth-0-3 down auto auto trunk UNKNOWN
eth-0-4 down auto auto trunk UNKNOWN
eth-0-5 down auto auto trunk UNKNOWN
eth-0-6 down auto auto trunk UNKNOWN
eth-0-7 down auto auto trunk UNKNOWN
eth-0-8 down auto auto trunk UNKNOWN
eth-0-9 down auto auto trunk UNKNOWN
eth-0-10 down auto auto trunk UNKNOWN
eth-0-11 down auto auto trunk UNKNOWN
eth-0-12 down auto auto trunk UNKNOWN
eth-0-13 down auto auto trunk UNKNOWN
eth-0-14 down auto auto trunk UNKNOWN
eth-0-15 down auto auto trunk UNKNOWN