TAP Series Switch Command Line Reference
This example shows how to set default radius-server dead time:
Switch(config-if)# no radius-server deadtime
Related Commands
show radius-server
14.35 radius-server retransmit
Use this command to specify the number of times the switch searches the list of RADIUS
server hosts before giving up.
Use the no form of this command to restore the default value.
Command Syntax
radius-server retransmit RETRANSMIT
RADIUS server retries (default 3)
Command Mode
Global Configuration
Default
3 attempts
Usage
The switch tries all servers, allowing each one to time out before increasing the retransmit
count. If the RADIUS server is only a few hops from the switch, we recommend that you
configure the RADIUS server retransmit rate to 5.
Examples
This example shows how to set radius-server retransmit:
Switch(config)# radius-server retransmit 10
This example shows how to set default radius-server retransmit:
To Next Page
Loading...
Need help?
General
