TAP Series Switch Command Line Reference
Default
None.
Usage
USB mass storage device must exist in the system. You can use the
“
umount
”
command to
uninstall the USB mass storage device.
Examples
The following example umount USB mass storage device:
Switch(config)# umount udisk:
Related Commands
format udisk:
17.5 management ip address
Use this command to set the management IP address on the Switch.
To remove the management IP address, use the no form of this command.
Command Syntax
management ip address IP_ADDR_MASK
IP address with mask length, in A.B.C.D/M
format
Command Mode
Global Configuration
Default
None
To Next Page
Loading...
