TAP Series Switch Command Line Reference
Usage
Use this command to configure the tunnel hash load balance.
This command is not supported on CTC5160 (GreatBelt) based switch.
Examples
This example shows how to set inner-filed hash load balance:
Switch(config)# port-channel tunnel-hash-mode inner
Related Commands
port-channel load-balance set
9.9 port-channel load-balance
Use this command to set load balance type for the Link Aggregation Control Protocol (LACP).
Use the no form of this command to set the load balance type for the Link Aggregation
Control Protocol (LACP) return to the default setting.
Command Syntax
port-channel load-balance (src-mac | dst-mac | src-ip | dst-ip | src-port | dst-port | src-dst-
ip | src-dst-mac | src-dst-port | src-dst-ip- src-dst-port)
no port-channel load-balance
Load balance by source MAC address
Load balance by destination MAC address
Load balance by source IP address
Load balance by destination IP address
Load balance by source port
Load balance by destination port
Load balance by MAC address.
Load balance by IP address
Load balance by ip and port
To Next Page
Loading...
Need help?
General
