FS TAP Series

TAP Series Switch Command Line Reference
20
Command Syntax
shutdown
no shutdown
Command Mode
Interface Configuration
Default
The interfaces are turned on by default.
Usage
Use the command to shutdown a port.
Examples
The following example shows how to shutdown a port:
Switch(config)# interface eth-0-1
Switch(config-if-eth-0-1)# shutdown
Related Commands
show interface status
1.10 description
Use this command to set the description on the interface.
Use the no form of this command to delete the description.
Command Syntax
description LINE
no description
LINE
Interface description string, which should
begin with a-z/A-Z, valid characters are 0-9A-