FS TAP Series - Speed

TAP Series Switch Command Line Reference
21
Za-z.-, and maximum length is 64 characters.
Command Mode
Interface Configuration
Default
The interface has no description by default.
Usage
Use this command to set the description on the interface.
Examples
The following example sets the description on the interface:
Switch(config)# interface eth-0-1
Switch(config-if-eth-0-1)# description Ethernet
The following example deletes the description on the interface:
Switch(config)# interface eth-0-1
Switch(config-if-eth-0-1)# no description
Related Commands
show interface description
1.11 speed
Use this command to specify the speed of a port.
Use the no form of this command to restore the default configuration.
Command Syntax
speed (auto| 10| 100| 1000| 2.5G| 5G| 10G| 40G| 100G)
no speed
auto
Enable auto negotiation for the speed of a
port.