FS TAP Series

TAP Series Switch Command Line Reference
212
Command Mode
Global Configuration
Default
0, 1, 10
Usage
0: The server privilege 0 mapping to switch level 1
1: The server privilege 1 mapping to switch level 2
9: The server privilege 2~9 mapping to switch level 3
Other: The server privilege 10~15 mapping to switch level 4
Examples
The following example shows how to set the mapping range:
Switch# configure terminal
Switch(config)# aaa privilege mapping 1 2 3
The following example shows how to set default mapping range:
Switch# configure terminal
Switch(config)# no aaa privilege mapping
Related Commands
None
14.55 debug aaa
Use this command to enable debugging aaa.
Use the no form of this command to disable debugging aaa.
Command Syntax
debug aaa ( all | packet | event | protocol | timer )