FS TAP Series

TAP Series Switch Command Line Reference
57
4 ACL Commands
4.1 show interface egress ip access-list
Use this command to show egress statistics of ip access-list on an interface.
Command Syntax
show interface egress ip access-list statistics IF_NAME
IF_NAME
Specify the interface name to show IP ACL
statistics.
This command supports physical or link
aggregation interfaces.
Command Mode
Privileged EXEC
Default
None
Usage
Use this command to show egress statistics of ip access-list. The interface name must be
specified.
Examples
This example shows the egress ip access-list statistic of interface eth-0-1:
Switch# show interface egress ip access-list statistics eth-0-1
egress flow f2
sequence-num 10 permit tcp src-port range 10 200 src-ip any dst-ip any ( bytes 124 packets 1 )
(total bytes 124 total packets 1 )