FS TAP Series

TAP Series Switch Command Line Reference
216
Related Commands
show console
14.58 privilege level
Use this command to set console privilege level for line.
Use the no form of this command to restore the default value.
Command Syntax
privilege level PRIVILEGE
no privilege level
PRIVILEGE
Default privilege level for line
Command Mode
Line-CON
Default
Default value is 1, range is from 1 to 4.
Usage
Use this command to set console privilege level for line.
Use the no form of this command to restore the default value.
Examples
The following example shows how to set console privilege level for line to 2:
Switch# configure terminal
Switch(config)# line console 0
Switch(config-line)# privilege level 2
The following example shows how to set console privilege level for line to default value: