FS TAP Series - timestamp sync

TAP Series Switch Command Line Reference
80
Sync Count : 0
Last Sync Time : Fri Mar 10 09:02:11 2017
Related Commands
timestamp sync
6.3 timestamp sync
Use this command configure to timestamp sync.
Use the no form of this command to restore the default value.
Command Syntax
timestamp sync (systime | none)
no timestamp sync
systime
Use the system time as time source.
none
Use the chip time as time source.
Command Mode
Global Configuration
Default
The default value is
“
none
”
.
Usage
When configured systime means sync from system time.
This command is not supported on CTC5160 (GreatBelt) based switch.
Examples
The following example shows how to config timestamp sync:
DUT1(config)# timestamp sync systime