FS TAP Series

TAP Series Switch Command Line Reference
287
Usage
Use this command to set the gateway on the Switch for management ip.
Use no form of this command to delete the gateway on the Switch for management ip
Examples
The following example sets the gateway of 192.168.100.254 for the switch.
Switch(config)# management route add gateway 192.168.100.254
The following example sets the gateway of 192.168.100.254 for the switch.
Switch(config)# no management route gateway
Related Commands
management ip address
17.7 service telnet enable
Use this command to set service telnet enable.
Use the no form of this command to set service telnet disable.
Command Syntax
service telnet enable
no service telnet enable
Command Mode
Global Configuration
Default
Enabled
Usage
Uses this command to enable the telnet service.