FS TAP Series

TAP Series Switch Command Line Reference
99
src-port-l4
dst-port-l4
Related Commands
port-channel load-balance set
9.4 no port-channel
Use this command to set port-channel load balance mode to default static mode which is
supported at CTC8096 (GoldenGate) based switch.
Command Syntax
no port-channel AGG_GID load-balance-mode
AGG_GID
Channel group id. Valid minimum ID is 1. Valid
maximum id is defined as blow:
for CTC5160 (GreatBelt) based system: 31.
for CTC8096(GoldenGate) based system: 55
Command Mode
Global Configuration
Default
Static mode
Usage
This command is not supported on CTC5160 (GreatBelt) based switch.
Examples
This example shows how to set port-channel load balance mode to the default setting:
Switch(config)# no port-channel 9 load-balance-mode
Related Commands
port-channel load-balance-mode