FS TAP Series

TAP Series Switch Command Line Reference
114
Command Syntax
ntp authentication (enable| disable)
Command Mode
Global Configuration
Default
Authentication is disabled by default.
Usage
When NTP authentication is enabled, the switch will synchronize the time with NTP servers
with trusted key only.
For more information about trusted key, please see the “ntp trustedkey” command.
Examples
The following example shows how to enables NTP authentication:
Switch(config)# ntp authentication enable
Related Commands
show ntp
10.10 ntp key
Use this command to configure value of the NTP key.
Use the no form of this command to delete the NTP key.
Command Syntax
ntp key NTP_KEYID KEY_STRING
NTP_KEYID
Authentication key (1 to 64000)
KEY_STRING
The value of the key