FS TAP Series

TAP Series Switch Command Line Reference
62
4.6 no sequence-num
Use this command to delete a filter from ip access-list.
Command Syntax
no sequence-num ACL_SEQ_NUM
ACL_SEQ_NUM
Sequence-number with the valid range 1
–
65535.
Command Mode
ACL Configuration
Default
None
Usage
Use this command to delete a filter from ip access-list.
Examples
This example shows how to delete a flow filter with sequence number 10 from ip acl acl1:
Switch(config-acl-acl1)# no sequence-num 10
Related Commands
show ip access-list
sequence-num
4.7 sequence-num acl_seq
Use this command to permit or deny packets matching the ip access-list filter.