FS TAP Series

TAP Series Switch Command Line Reference
28
2 FLOW Commands
2.1 show interface flow statistics
Use this command to show statistics information which matched the flow on the interface.
Command Syntax
show interface flow statistics IF_NAME (FLOW_SEQ_NUM|)
IF_NAME
Specify an interface name to show flow
statistics.
This command supports physical or link
aggregation interfaces.
FLOW_SEQ_NUM
Specify sequence-number to show flow
statistics.
If the sequence-number is not specified, this
command indicates that all rules on this
interface should be shown.
Command Mode
Privileged EXEC
Default
None
Usage
Use this command to show statistics information which matched the flow on the interface.
Interface name must be specified.
Examples
The following example shows how to display the flow statistic on interface eth-0-1: