FS TAP Series

TAP Series Switch Command Line Reference
336
Switch(config)# clock set datetime 22:43:23 9 26 2017
Related Commands
show clock
19.15 clock set timezone
Use this command to set timezone.
Use the no form of this command to restore the default value.
Command Syntax
clock set timezone Z_NAME ( add | minus ) TZ_HOURS ( TZ_MIN ( TZ_SEC |) |)
no clock set timezone
Z_NAME
Zone name, must be less than 32 characters
add
Specify the time offset is positive from UTC
minus
Specify the time offset is negative from UTC
TZ_HOURS
Hours offset from UTC, must be range 0~23
TZ_MIN
Minutes offset from UTC, must be range 0~59
TZ_SEC
Seconds offset from UTC, must be range 0~59
Command Mode
Global Configuration
Default
None
Usage
None
Examples
This example shows how to set the clock timezone :