FS TAP Series

TAP Series Switch Command Line Reference
50
This command does not supported on CTC5160 (GreatBelt) based switch.
Examples
This example shows how to add a remark to describe the inner-match:
Switch(config-inner-match-im1)# remark inner-match-1
This example shows how to delete the remark of the inner-match.
Switch(config-inner-match-im1)# no remark
Related Commands
show inner-match
3.4 no sequence-num
Use this command to delete a filter from inner-match.
Command Syntax
no sequence-num MATCH_SEQ_NUM
MATCH_SEQ_NUM
Sequence-number with the valid range 1 –
65535.
Command Mode
Inner-match Configuration
Default
None
Usage
Use this command to delete a filter from inner-match.
This command does not supported on CTC5160(GreatBelt) based switch.