FS TAP Series

TAP Series Switch Command Line Reference
49
When the name is not used by any inner-match, this command is to create the inner-match
firstly and then enter the inner-match configuration mode.
This command dose not supported on CTC5160 (GreatBelt) based switch.
Examples
This example shows how to create a inner-match named im1 and then enter the inner-match
configuration mode.
Switch(config)# inner-match im1
Switch(config-inner-match-im1)#
Related Commands
show inner-match
3.3 remark
Use this command to add remarks for the inner-match.
Command Syntax
remark NAME_STRING
no remark
NAME_STRING
Remark string for the inner-match, which
should begin with a-z/A-Z/0-9, valid characters
are 0-9A-Za-z.-, maximum length is 100
characters.
Command Mode
Inner-match Configuration
Default
Default is no remarks of inner-match.
Usage
The remarks are up to 100 characters.