FS TAP Series

TAP Series Switch Command Line Reference
103
Usage
The no form of this command with the hash field means delete the load balance type.
The no form of this command without the hash field means restore the default value.
This command is not supported on CTC5160 (GreatBelt) based switch.
Examples
This example shows how to configure the load balance type for Link Aggregation Control
Protocol (LACP):
Switch(config)# port-channel load-balance set src-mac
Related Commands
show port-channel load-balance
9.8 port-channel load-balance tunnel-hash-mode
Use this command to configure the load balance tunnel hash algorithm for the Link
Aggregation Control Protocol (LACP).
Command Syntax
port-channel load-balance tunnel-hash-mode (both | outer | inner)
both
Use both field for tunnel packet load balance.
outer
Use outer field for tunnel packet load balance.
inner
Use inner field for tunnel packet load balance.
Command Mode
Global Configuration
Default
both