FS TAP Series

TAP Series Switch Command Line Reference
150
Related Commands
show snmp-server sys-info
13.13 snmp-server version
To specify the support of SNMP version, use the snmp-server version command in global
configuration mode.
Use the no form of this command to restore the default value.
Command Syntax
snmp-server version (all| v1| v2c)
no snmp-server version
all
Support all versions (v1, v2c, and v3)
v1
Support only v1 version
v2c
Support only v2c version
Command Mode
Global Configuration
Default
Support v1 and v2c SNMP versions.
Usage
This command is used to set the SNMP version the switch supported.
Examples
The following example shows how to set SNMP –server to support all versions
Switch(config)# snmp-server version all
The following example shows how to restore the SNMP –server to support default versions:
Switch(config)# no snmp-server version