FS TAP Series

TAP Series Switch Command Line Reference
237
16 GLOBAL Commands
16.1 show debugging
To display the debugging status, use the show debugging command in EXEC mode.
Command Syntax
show debugging ( aaa | sflow |) (detail |)
aaa
Display the states of aaa debugging
sflow
Display the states of sflow debugging
detail
Display the detailed information of debugging
Command Mode
Privileged EXEC
Default
None
Usage
Use this command to display the debugging status.
Examples
The following is sample output from the show debugging aaa command:
Switch# show debugging aaa detail
Module Feature Type Status
------------+----------------+--------------------+------
auth aaa event on
aaa packet on
aaa protocol off
aaa timer on