FS TAP Series

TAP Series Switch Command Line Reference
30
Examples
The following example shows how to clear statistics information which matched the flow on
the interface:
Switch# clear interface flow statistics eth-0-1
The following example shows the result after using the command in the example above:
Switch# show interface flow statistics eth-0-1
TAP group name: g1
flow name: f1
sequence-num 10 permit any src-ip 10.10.10.0 0.0.0.255 dst-ip any ( bytes 0 packets 0 )
sequence-num 20 deny any src-ip any dst-ip any ( bytes 0 packets 0 )
(total bytes 0 total packets 0 )
Related Commands
show interface flow statistics
2.3 show flow
Use this command to show the configuration of flow.
Command Syntax
show flow (NAME_STRING|)
NAME_STRING
Flow name, up to 20 characters.
If the flow name is not specified, this
command indicates that all flows should be
shown.
Command Mode
Privileged EXEC
Default
None
Usage
Use this command to show the configuration of flow.