FS TAP Series

TAP Series Switch Command Line Reference
146
Related Commands
snmp-server view
13.9 snmp-server enable
To enable the SNMP function, use the snmp-server enable command in global configuration
mode.
Use the no form of this command to disable the SNMP-server.
Command Syntax
snmp-server enable
no snmp-server enable
Command Mode
Global Configuration
Default
SNMP function is disabled.
Usage
The command is used to enable snmp global.
Examples
The following example shows how to set the snmp-server enable:
Switch(config)# snmp-server enable
The following example shows how to set the snmp-server disable:
Switch(config)# no snmp-server enable
Related Commands
show snmp