FS TAP Series

TAP Series Switch Command Line Reference
203
Command Mode
Global Configuration
Default
None
Usage
If this command is set, user need to provide the password when enter Privileged EXEC mode.
Examples
The following example shows how to set the password:
Switch(config)# enable password 654321
Switch(config)# exit
Switch# disable
Switch> enable
Password:
Switch#
The following example shows how to unset the password:
Switch(config)# no enable password
Related Commands
enable
disable
14.47 enable password privilege
Use this command to set the password which is needed when user enter Privileged EXEC
mode.
Use the no form of this command to unset the password when user enter Privileged EXEC
mode.
Command Syntax
enable password privilege PRIVILEGE ( 8 |) PASSWORD