FS TAP Series

TAP Series Switch Command Line Reference
90
Use the no form of this command to restore the default value of Secure Shell (SSH)
authentication timeout on your switch
Command Syntax
ip ssh server authentication-timeout SSHAUTHTIMEOUT
no ip ssh server authentication-timeout
SSHAUTHTIMEOUT
Timeout seconds(default: 120)
Command Mode
Global Configuration
Default
The default value is 120 seconds.
Usage
None
Examples
The following examples configure SSH authentication timeout on your switch:
Switch(config)# ip ssh server authentication-timeout 100
The following examples restore SSH authentication timeout to default value on your switch:
Switch(config)# no ip ssh server authentication-timeout
Related Commands
show ip ssh server status
8.8 ip ssh server authentication-type
To configure Secure Shell (SSH) authentication type on your switch, use the ip ssh server
authentication-type command in global configuration mode.