FS TAP Series

TAP Series Switch Command Line Reference
91
Use the no form of this command to restore the default value of Secure Shell (SSH)
authentication type on your switch.
Command Syntax
ip ssh server authentication-type ( all | ( password | public-key | rsa ) )
no ip ssh server authentication-type
all
Enable all authentication type
password
Enable password
public-key
Enable public key
rsa
Enable rsa
Command Mode
Global Configuration
Default
The default authentication type is public-key and password.
Usage
To configure Secure Shell (SSH) authentication type on your switch, use the ip ssh server
authentication-type command in global configuration mode.
Use the no form of this command to restore the default value of Secure Shell (SSH)
authentication type on your switch.
Examples
The following examples configure SSH authentication type on your switch:
Switch(config)# ip ssh server authentication-type password