FS TAP Series

TAP Series Switch Command Line Reference
132
Default
Default timestamp format is BSD.
Usage
This command is used to specify the timestamp in logger message.
Examples
The following shows how to set the logging timestamp to iso:
Switch(config)# logging timestamp iso
The following shows how to set the logging timestamp to default value:
Switch(config)# no logging timestamp
Related Commands
show logging
12.13 logging server
To enable the logging to the remote logging servers, use the logging server command in
Global Configuration mode.
Command Syntax
logging server (enable| disable)
enable
Enable logging server
disable
Disable logging server
Command Mode
Global Configuration
Default
Logging operations is disabled.