FS TAP Series

TAP Series Switch Command Line Reference
115
Command Mode
Global Configuration
Default
There is no ntp key by default
Usage
Use this command to create a value for a NTP key.
Examples
In the following example, the value 321 is given to the NTP key 123:
Switch(config)# ntp key 123 key123
Related Commands
show ntp key
10.11 ntp trustedkey
Use this command to authenticate the identity of a system to which Network Time Protocol
(NTP) will synchronize.
Use the no form of this command to disable authentication of the identity of the system.
Command Syntax
ntp trustedkey NTP_KEYID
no ntp trustedkey NTP_KEYID
NTP_KEYID
Authentication key to use when sending
packets to this peer (1 to 64000)
Command Mode
Global Configuration