TAP Series Switch Command Line Reference
Use this command to show the configuration of inner-match.
Command Syntax
show inner-match (INNER_MATCH_NAME |)
Specify an inner-match name to display.
The inner match name should begin with a-
z/A-Z/0-9, valid characters are 0-9A-Za-z.-, and
maximum length is 20 characters.
If the parameter
“
INNER_MATCH_NAME
”
is
not specified, the command indicates that all
inner-matches on this device should be
displayed; otherwise only the specified one
should be displayed
Command Mode
Privileged EXEC
Default
None
Usage
The inner-match name can be specified or not.
This command is not supported on CTC5160 (GreatBelt) based switch.
Examples
This example shows the configuration of all inner-match:
To Next Page
Loading...
