FS TAP Series - show sflow

TAP Series Switch Command Line Reference
235
Default
Debugging sflow is disabled by default.
Usage
Use this command to turn on the debug switches of sflow module.
Examples
In the following example shows how to enable debugging sflow all:
Switch# debug sflow all
In the following example shows how to enable debugging sflow all:
Switch# no debug sflow all
Related Commands
show debugging
15.9 show sflow
Use this command to show the running information of sflow.
Command Syntax
show sflow
Command Mode
Privileged EXEC
Default
None
Usage
Use this command to show the running information of sflow.