TAP Series Switch Command Line Reference
Use this command to configure the truncation length information.
Use the no form of this command to restore the default value.
Command Syntax
truncation TRUNCATION_LEN
Truncation length.
Valid range is 64-144.
Command Mode
Global Configuration
Default
Truncation length is 144 by default.
Usage
CRC should be re-calculating after packet is truncated. The truncation length include CRC
field.
This command is not supported on CTC5160 (GreatBelt) based switch.
Examples
The following example shows how to set truncation length as 64:
Switch(config)# truncation 64
Enable truncation for TAP group tap1:
Switch(config)# tap-group tap1
To Next Page
Loading...
