TAP Series Switch Command Line Reference
Command Syntax
logging file (enable| disable)
Write the logs into log file
Do not write the logs into log file
Command Mode
Global Configuration
Default
Logging file is enabled
Usage
If logging file will enabled, the log will be saved to flash:/syslog every 10 minutes.
Examples
The following shows how to enable logging file function:
Switch(config)# logging file enable
Related Commands
show logging
To set severity level while writing logs into files, use the logging level file command in Global
Configuration mode.
Use the no form of this command to restore the default value.
To Next Page
Loading...
Need help?
General
