FS TAP Series

TAP Series Switch Command Line Reference
193
Switch(config-if)# no radius-server retransmit
Related Commands
show radius-server
14.36 radius-server timeout
Use this command to set the interval for which a switch waits for a server host to reply.
Use the no form of this command to restore the default value.
Command Syntax
radius-server timeout TIMEOUT
TIMEOUT
RADIUS server timeout in seconds (default 5)
Command Mode
Global Configuration
Default
5 seconds
Usage
Use this command to set the number of seconds a switch waits for a server host to reply
before timing out. If the RADIUS server is only a few hops from the switch, we recommend
that you configure the RADIUS server timeout to 15 seconds.
Examples
This example shows how to set radius-server timeout:
Switch(config)# radius-server timeout 10
This example shows how to set default radius-server timeout:
Switch(config-if)# no radius-server timeout