FS TAP Series User Manual

TAP Series Switch Command Line Reference
157
13.19 snmp-server trap delay linkdown
To configure the trap delay linkdown time, use the snmp-server trap delay linkdown
command in global configuration mode.
Use the no form of this command to restore the default value.
Command Syntax
snmp-server trap delay linkdown TRAP_DELAY_TIME
no snmp-server trap delay linkdown
TRAP_DELAY_TIME
Linkdown trap delay time
Command Mode
Global Configuration
Default
0
Usage
This command is used to set the trap delay time for link down interface.
Examples
The following example shows how to set the delay time to 10 seconds:
Switch(config)# snmp-server trap delay linkdown 10
The following example shows how to restore the delay time to default value:
Switch(config)# no snmp-server trap delay linkdown
Related Commands
snmp-server trap enable

FS TAP Series Specifications

General

Brand	FS
Model	TAP Series
Category	Switch
Language	English