FS TAP Series - egress

TAP Series Switch Command Line Reference
75
5.4 egress
Use this command to add a physical or link aggregation interface to the egress direction of
the TAP group.
Use the no form of this command to remove the interface.
Command Syntax
egress IF_NAME (timestamp|)
no egress IF_NAME
IF_NAME
Specify the interface name.
This command supports physical or link aggregation interfaces.
Command Mode
configure-tap-view
Default
None
Usage
None
Examples
The following example shows how to add an egress-interface eth-0-9:
Switch(config)# tap-group tap1
Switch(config-tap-tap1)# egress eth-0-9
The following example shows how to add an egress-interface agg1:
Switch(config)# interface eth-0-10
Switch(config-if-eth-0-10)# static-channel-group 1
Switch(config)# interface eth-0-11
Switch(config-if-eth-0-11)# static-channel-group 1
Switch(config)# tap-group tap1
Switch(config-tap-tap1)# egress agg1