TAP Series Switch Command Line Reference
Related Commands
schedule reboot delay
schedule reboot at
Use the stm prefer Global Configuration command to configure the profile used in Switch
Table Management (STM) resource allocation. You can use profile to allocate system memory
to best support the features being used in your application. Use profile to approximate the
maximum number of unicast MAC addresses, quality of service (QoS) access control entries
(ACEs) and unicast routes.
Command Syntax
stm prefer default
Command Mode
Global Configuration
Default
System use the default profile when first boot up, this profile balance all the features.
Usage
Users must reload the switch for the configuration to take effect.
Examples
This example shows how to configure the default profile on the switch:
Switch(config)# stm prefer default
% Changes to STM profile have been stored, but cannot take effect until the next reload. Use 'show
stm prefer current' to see what STM profile is currently active.
Related Commands
show stm prefer current
To Next Page
Loading...
Need help?
General
