FS TAP Series

TAP Series Switch Command Line Reference
295
Examples
The following example is to show management interface ip address:
Switch# show management ip address
Management IP address: 10.10.39.131/23
Gateway: 0.0.0.0
Related Commands
management ip address
management route gateway
18.7 show startup-config
Use this command to show contents of startup configuration.
Command Syntax
show startup-config
Command Mode
Privileged EXEC
Default
None
Usage
Use this command to show contents of startup configuration.
Examples
The following example is to show contents of startup configuration:
Switch# show startup-config
hostname Switch
timestamp sync systime
enable password abc
!