FS TAP Series

TAP Series Switch Command Line Reference
236
Examples
This example shows how to show the sflow running information:
Switch# show sflow
sFlow Version: 4
sFlow Global Information:
Agent IPv4 address : 10.0.0.254
Counter Sampling Interval : 10 seconds
Collector 1:
IPv4 Address: 10.0.0.254
Port: 3000
sFlow Port Information:
Flow-Sample Flow-Sample
Port Counter Flow Direction Rate
--------------------------------------------------------
eth-0-7 Enable Enable Input 2048
Related Commands
sflow enable
sflow agent
sflow collector
sflow counter interval
sflow counter-sampling enable
sflow flow-sampling rate
sflow flow-sampling enable