FS TAP Series

TAP Series Switch Command Line Reference
56
Default
None
Usage
Wildcard bits in this command are used as reversed. That means value and wildcard bits have
same length, If a bit in wildcard is 0 means this bit needs to check, otherwise this bit should
be ignored.
E.g.: ip address 10.10.10.0 wildcard 0.0.0.255 means 256 ip addresses from 10.10.10.0 to
10.10.10.255.
Layer 4 information （e.g. tcp/udp port）and fragment information are exclusive.
Notice:
This command does not supported on CTC5160 (GreatBelt) based switch.
Examples
This example shows how to add an inner-match filter with sequence number 10 to im1:
Switch(config)# inner-match im1
Switch(config-inner-match-im1)# sequence-num 10 match icmp src-ip 10.10.10.0 0.0.0.255 dst-ip
any
Related Commands
no sequence-num