FS TAP Series - Page 13

TAP Series Switch Command Line Reference
13
Examples
The following example shows how to display the statistic of interface eth-0-1
：
Switch# show interface summary eth-0-1
RXBS: rx rate (bits/sec) RXPS: rx rate (pkts/sec)
TXBS: tx rate (bits/sec) TXPS: tx rate (pkts/sec)
Interface Link RXBS RXPS TXBS TXPS
----------+------+--------------+--------------+--------------+--------------
eth-0-1 DOWN 0 0 0 0
The following example shows how to display the statistic of interfaces:
Switch# show interface summary eth-0-1
Switch# show interface summary
RXBS: rx rate (bits/sec) RXPS: rx rate (pkts/sec)
TXBS: tx rate (bits/sec) TXPS: tx rate (pkts/sec)
Interface Link RXBS RXPS TXBS TXPS
----------+------+--------------+--------------+--------------+--------------
eth-0-1 UP 0 0 0 0
eth-0-2 UP 0 0 0 0
eth-0-3 UP 0 0 0 0
eth-0-4 UP 0 0 0 0
eth-0-5 UP 0 0 0 0
eth-0-6 UP 0 0 0 0
eth-0-7 UP 0 0 0 0
eth-0-8 UP 0 0 0 0
eth-0-9 UP 0 0 0 0
eth-0-10 UP 0 0 0 0
eth-0-11 UP 0 0 0 0
eth-0-12 UP 0 0 0 0
eth-0-13 UP 0 0 0 0
eth-0-14 UP 0 0 0 0
eth-0-15 UP 0 0 0 0
eth-0-16 UP 0 0 0 0
eth-0-17 UP 0 0 0 0
eth-0-18 UP 0 0 0 0
eth-0-19 UP 0 0 0 0
eth-0-20 UP 0 0 0 0
eth-0-21 UP 0 0 0 0
eth-0-22 UP 0 0 0 0
eth-0-23 UP 0 0 0 0
eth-0-24 UP 0 0 0 0
Related Commands
show interface