TAP Series Switch Command Line Reference
snmp-server community a1 read-write
snmp-server community a123456789012345678901234567890123456 read-write
!
snmp-server trap target-address mgmt-if 3.3.3.3 community public
!
snmp-server inform target-address mgmt-if 10.10.27.233 community sysname
!
management ip address 10.10.39.104/23
management route add gateway 10.10.39.254
!
port-channel load-balance hash-arithmetic crc
port-channel load-balance set vxlan-vni
port-channel load-balance set inner-dst-mac
!
ip access-list a
!
ip access-list e1
!
ip access-list aaaa
!
inner-match imf1
remark vxlan-inner-match
!
inner-match inner-vxlan
sequence-num 1 match any src-ip host 1.1.1.1 dst-ip any
!
flow vxlan
sequence-num 10 permit udp dst-port eq 4789 src-ip host 1.2.3.4 dst-ip any strip-header
!
flow outer-vxlan type decap
sequence-num 10 permit udp dst-port eq 4789 vxlan-vni 10 0x0 src-ip host 1.2.3.4 dst-ip any
inner-match inner-vxlan strip-header
!
sflow enable
sflow agent ip 10.0.0.254
sflow counter interval 10
!
sflow collector mgmt-if 10.10.39.106
!
interface eth-0-1
description TenGigabitEthernet
speed 1000
shutdown
!
interface eth-0-2
shutdown
!
interface eth-0-3
shutdown
static-channel-group 10
!
interface eth-0-4
shutdown
static-channel-group 10