TAP Series Switch Command Line Reference
z.-, maximum length is 20 characters.
Command Mode
Interface Configuration
Default
None.
Usage
Use this command to apply IPv4 access list on the outbound direction of an interface
Use the no form of this command to remove the IPv4 access list.
This command supports physical or link aggregation interfaces.
Examples
The example shows how to apply the access list f1 to egress direction eth-0-9
Switch(config)# interface eth-0-19
Switch(config-if-eth-0-19)# egress f1
Related Commands
ip access-list
To Next Page
Loading...
