5.5 Copy Mode Settings
143
5
System Administration Mode Settings
5. Reduce/Enlarge
Set the default of Reduce/Enlarge in the Basic Copying screen.
Set the ratio from a total of nine standard ratios: seven buttons registered to the R/E Preset buttons,
100% and Auto %.
Enter the setting values using the numeric keypad referring to the table below.
(Default is 0 as 100%.)
When the Paper Tray default is set to Auto, Auto % cannot be set at Reduce/Enlarge.
●
For details on setting the R/E Preset buttons, see “5.5.5 Reduce/Enlarge Presets” (P. 155).
●
For details about Reduce/Enlarge, see “3.4 Making Enlarged/Reduced Copies - Reduce/Enlarge” (P. 306) in
“Part 2 Copier”.
6. Paper Supply
Set the default of Paper Supply in the Basic Copying screen.
When the Reduce/Enlarge default is set to Auto %, Auto cannot be set at Paper Tray.
Enter the setting values using the numeric keypad referring to the table below.
(Default is 0 as Auto.)
When Tray 5 (Bypass) is set at 6. Paper Supply, and Finisher Tray is set at 9. Output Destination, the set details
are canceled, and the Paper Supply setting in the Basic Copying screen is set to Auto.
For details about Paper Supply, see “3.5 Selecting the Paper to Use for Copying - Paper Supply” (P. 317) in
“Part 2 Copier”.
Setting Value Description
0 100%
1 Ratio currently set to R/E Preset 1
2 Ratio currently set to R/E Preset 2
3 Ratio currently set to R/E Preset 3
4 Ratio currently set to R/E Preset 4
5 Ratio currently set to R/E Preset 5
6 Ratio currently set to R/E Preset 6
7 Ratio currently set to R/E Preset 7
8Auto %
Setting Value Description
0Auto
1Tray 1
2Tray 2
3Tray 3
4Tray 4
5 Tray 5 (Bypass)
To Next Page
Loading...
Need help?
General
