Chapter 2 Troubleshooting
2.2 Status Code List
2-32
041-347
MCU Internal Error
041-347
Code:xxxxxxxx
Restart Printer
<IOT I/F Failure>
MCU Internal Error (I/F part).
Replace the
PWBA MCU.
(REP 18.2)
Replace the
PWBA ESS.
(REP18.1)
042-313
Fan Motor Error
042-313
Restart Printer
<LVPS Fan Motor Failure>
MCU detects an error upon receiving error signal
from the LVPS Fan.
FIP1.8
042-330
Fan Error
042-330
Restart Printer
<Rear Fan Failure>
MCU detects an error upon receiving error signal
from the Rear Fan.
FIP1.9
042-700
Printer Error
042-700
Restart Printer
<IOT Over Heat Stop>
The temp. Sensor sensed high temperature.
FIP1.10
050-130
Paper Jam
Open Rear Door
and remove paper
<IOT Remain Zone Fusing Jam>
When Dynamic Jam (cause) was detected:
- Exit On Jam
- Exit Off Jam
- Exit Off early Jam
When Static Jam (collateral) was detected:
- Exit Sensor On
FIP1.11
050-131
Paper Jam
Open Rear Door
and remove paper
<IOT Remain Zone Duplex Jam>
When Dynamic Jam (cause) was detected:
- Duplex Regi On Jam
FIP1.12
050-132
Paper Jam
Pull Out Bypass Tray
Unit, Tray1,
& Tray2. Open Rear
Door.
Clear Jam.
<IOT Remain Zone Regi + MSI + T1 + T2 Jam>
When Dynamic Jam (cause) was detected:
- Regi Off Jam
When Static Jam (collateral) was detected:
- Regi Sensor On
FIP1.13
050-133
Paper Jam
Pull Out Bypass Tray
Unit, Tray1,
& Tray2. Clear Jam.
Return
Paper Trays. Press OK
to Start.
<IOT Zone MSI + T1 + T2 Jam>
When Dynamic Jam (cause) was detected:
- Tray2 Misfeed Jam
FIP1.13
050-134
Paper Jam
Pull Out Bypass Tray
Unit, Tray1.
Clear Jam. Return
Paper Trays.
Press OK to Start.
<IOT Zone MSI+T1 Jam>
When Dynamic Jam (cause) was detected:
- MSI Misfeed Jam
- Tray1 Misfeed Jam
FIP1.13
050-142
Paper Jam
Pull Out Bypass Tray
Unit, Tray1.
Open Rear Door.
Clear Jam.
<IOT Remain Zone Regi + MSI + T1 Jam>
When Dynamic Jam (cause) was detected:
- Regi Off Jam
When Static Jam (collateral) was detected:
- Regi. Sensor On
FIP1.13
Status
Code
LCD Message Name/Description of Error FIP
To Next Page
Loading...
