Chapter 2 Troubleshooting
2.2 Status Code List
2-34
077-108 -
<Exit Off early Jam>
After the Exit Sensor turned ON, the Exit Sensor
turned OFF before the specified time.
FIP1.11
077-109 -
<Exit Off Jam>
After the Regi. Sensor turned OFF, the Exit Sensor
did not turn OFF within the specified time.
FIP1.11
077-300
Front Cover Open
Close Front Cover
<IOT Cover Front Open>
Beep sounds after Front Cover remains open for 3
minutes.
FIP1.20
077-304
Rear Door Open
Close Rear Door
<IOT Cover Rear Open>
The Rear Cover is open.
FIP1.21
077-312
Tray Configure Error
077-312
Restart Printer
<Tray Configure Error>
Tray configuration error was detected.
(including all of the wrong configurations)
FIP1.22
091-401
XXXXXXXXXXXXXXX
X
Order Drum Cartridge
<Drum Near Life End>
It was detected that the Drum needed to be
replaced soon.
Replace the
Drum Cartridge
[XERO ASSY]
(PL8.1.1)
091-402
XXXXXXXXXXXXXXX
X
Replace Drum Car-
tridge
<Drum Quality Life End>
A warning that the Drum needed to be replaced
soon was detected.
Replace the
Drum Cartridge
[XERO ASSY]
(PL8.1.1)
091-913
Drum Cartridge Life
Over
Replace Drum Car-
tridge
<Drum Cartridge End of Life>
It was detected that the Drum needed to be
replaced soon.
Replace the
Drum Cartridge
[XERO ASSY]
(PL8.1.1)
091-914
Drum Cartridge Error
091-914
Reseat or Replace
Drum Cartridge
<IOT Drum Communication Fail>
Communication failure with Drum CRUM was
detected.
FIP1.23
091-915
Drum Error
091-915
Reseat or Replace
Drum Cartridge
<Drum CRUM Data Broken Fail>
Malfunction of Drum CRUM was detected.
FIP1.23
091-921
Drum Cartridge
Detached
091-921
Insert Drum Cartridge
<IOT Drum Detached>
It was detected that the Drum CRUM is not at the
specified position.
(Loose CRUM)
FIP1.23
091-953
Drum Tape Staying
Pull out Tape Drum
Cartridge
<Drum Tape Staying>
The remaining Tape of the Drum Cartridge was
detected.
Remove the
Drum Cartridge
Tape
091-963
Invalid Drum Cartridge
Reseat or
Replace Drum Car-
tridge
<IOT Drum CRUM ID Error>
The Drum CRUM ID error was detected.
FIP1.23
092-315
ATC Sensor Error
092-315
Restart Printer
<ATC Fail>
The ATC Sensor error was detected.
FIP1.24
Status
Code
LCD Message Name/Description of Error FIP
To Next Page
Loading...
